Teledyne 9060 - Zirconium oxide flue gas oxygen analyzer - Manual (Page 26)

9060-Zirconia Analyser
INSTALLING & COMMISSIONING
3
SECTION
NUMBER INSTALLATION
3.1 MOUNTING THE TRANSMITTER
3.2a INSTALLING AN OXYGEN PROBE
3.2b INSTALLING A 1234 OXYGEN SENSOR
3.3 INSTALLING THE AUXILIARY THERMOCOUPLE
3.4 SHIELD CONNECTIONS
3.5 ELECTRICAL CONNECTIONS
3.6 HEATER INTERLOCK RELAYS
3.7a CONNECTING AN OXYGEN PROBE CABLE
3.7b CONNECTING A 1234 SENSOR CABLE
3.8 CONNECTING THE AUXILIARY THERMOCOUPLE (OPTIONAL)
3.9 CONNECTING THE OUTPUT CHANNELS
3.10 CONNECTING THE ALARMS
3.11 CONNECTING THE AUTOMATIC PURGE & CALIBRATION CHECK SYSTEM
3.12 CONNECTING REFERENCE AIR
3.13 CONNECTING THE DUAL FUEL INPUT
3.14 CONNECTING THE PRINTER
3.15 CONNECTING THE TRANSMITTER TO A MODBUS™ NETWORK
COMMISSIONING
3.16 CONNECTING POWER
3.17 COMMISSIONING - SET-UP MODE
3.18 COMMISSIONING - RUN MODE
3.19 BURNER BY-PASS SWITCH
3.20 CHECKING ALARMS
3.21 PROBE CALIBRATION CHECK
3.22 FILTER PURGE SET-UP PROCEDURE
3.23 CALIBRATION CHECK GAS SET-UP PROCEDURE
3.24 DUST IN THE FLUE GAS
3.25 STRATIFICATION
3.26
CONNECTING A PRESSURE TRANSDUCER