Multichannel Systems Roboocyte2 Manual User Manual
Page 54
Roboocyte2 Manual
50
Click the "Check" button in the "Resistance" window to display the actual electrode resistances,
which will give back reasonable values only when the electrodes are immersed in an appropriate
bath solution.
In the "Display" section you can switch the Roboocyte2 display between the "Welcome Screen"
and the "Generic Screen" and the "Measurement Screen".
Z-Axis Section
All functions in the "Z-Axis" section refer to movements of the z-axis.
Click the "Reference" button to start the reference movement of the z-axis. After performing
a reference movement the z-axis stops at a defined zero-position.
Click the "Home" button to move the z-axis to the home (zero) position.
Click the "Park Pos" button to move the z-axis down to the park position.
Click the "Tube" button to move the z-axis to the tube in the back of the carrier.
Click the "Oocyte" button to move the z-axis down to oocyte position.
Click the "Liquid" button to move the z-axis down to the liquid position.
Use the arrow buttons to move the z-axis up and down, either in "Slow" or "Fast" mode.