Luminex xPONENT 4.2 for FLEXMAP - Manual (Page 20)

To Go to Expanded Help
Adjust the sample probe height Home > Probe and Heater Adjusting the Sample Probe
Initialize the system Home > System Initialization Running the System Initialization
Routine
Run an assay Home > Create a new Batch
from a new protocol, or Home
> Create a new Batch using
the highlighted protocol below Create a New Batch from a New
Protocol
Create a New Batch from an
Existing Protocol
Analyze Results > Saved Batches Performing Analysis
Print reports Results > Reports Reports Tab
System Info Tab
Maintenance > System Info
Use this tab to view information and diagnostics about the Luminex instrument.
This tab contains the following information:
• Software
• Version
• Operating System
• Licensing
• Instrument Type
xPONENT ® for FLEXMAP 3D ®
6