Apple Xserve G5 - Manual (Page 72)

70 - Xserve G5 Take Apart Logic Board
6. Using a Phillips screwdriver, release the thumbscrew that secures the logic board to
the chassis (indicated by a triangle in the illustration below).
Note: The thumbscrew is captive; you cannot remove it.
7. Grasping the logic board by its long edges, move it forward and up slightly to release it
from the four mounting pegs (indicated by squares in the illustration below).
Caution: Be careful not to flex the logic board, which could damage the board or its
components. To minimize flexing, always grasp the logic board by its long edges when
removing or installing it.
8. Grasping the long edges of the logic board, tilt up the front end of the logic board so
that the board ports clear the openings in the back of the enclosure.
9. Grasp the logic board by its long edges and remove it from the server. Make sure the
board clears the two chassis release levers.