CNB MDC4050VR - Manual (Page 37)

37
Network Camera_ User manual
angle). If counterclockwise direction was set, the scanning
covers the wide region, while the scanning covers narrow
region if clockwise direction was selected.
Note : Endless Function of OSD Menu should be
Off.
Select the rotational direction of camera, when Endless
Rotation is On.
Activate/Deactivate the Endless Function.
The configured status can be checked only on OSD Menu.
Activate/Deactivate the Flickerless Function.
Activate/Deactivate the BLC Function.
Activate/Deactivate the WDR Function.
This function is available on some specific products.
Activate/Deactivate the DSS Function.
Reverse the Left/Right of Video.
Reverse the Up/Down of Video.
When passing over the 90 degree as the limited point of Tilt
operation, it will rotate the camera by 180 degree for
continuous movement.
Activate/Deactivate the Digital Zoom of Camera Module.
Change the Setting Value of Camera Module.
Select the category to change and select the Setting Value, then click on
SET button.
Designate or change the PTZ Operation against each Alarm Input.
Set the N.O. / N.C. as activation condition and select the PTZ Command
to perform accordingly, then press SET to save the setting value.
Enable/Disable the Alarm.
For the Alarm Triggered operation, alarm should be enabled.
Add or Change the Setting of Privacy mask.
Select the number of the mask to set then click on SET. The Privacy
Setting is displayed on the Screen.