CNB MDC4050VR - Manual (Page 29)

29
Network Camera_ User manual
Factory Default Setting
Re-initialize the system to factory default state.
By checking on a Radio button “Except Network Configuration”, you can
preserve the parameters for the network in case of remote upgrade.
Checking on “All”, will return all the parameters to factory default state.
Once all the values are set to factory default state, the product
should be set-up again using IP-Installer.
System Restart
Perform remote reset by clicking on the “CONFIRM” button.
[Important] To apply upgraded contents, you should perform
System Restart.
All previous connections will be disconnected upon reset. Device
does not resume the connections and the user must re-connect
to the product manually.
The upgrade of product will change the F/W or other programs installed on the system. To
operate the system with the changes, you must perform “System Restart” after the upgrade .
After restoring the Factory Default, if you need to access to the product with the same access
information, you must select “Preserver Network Configuration”.
If you do the Factory Default by selecting “All”, all network parameters will be initialized, you
need to assign the network parameters again for use of the product.