CNB MDC4050VR - Manual (Page 13)

13
Network Camera_ User manual
DHCP Setup
When the DHCP server assigns IP address automatically, select ‘DHCP’
in the network type. Select this mode in case of Cable Modem.
Refer to [IP-installer user’s guide] for “Host name and domain for
Cable Modem.
Clone MAC Refer to [IP-installer user’s guide] for “Clone MAC”.
Port Change
Port number should be positive integer below 65,535. Duplication of port number is
prohibited.
HTTP HTTP port is used for the connection to the admin mode. Default is 80.
RTSP
The RTSP port is used for transmitting real time audio/video data from
the product. Default is TCP 554.
RTSP Address : rtsp://camera_ip_address[:rtsp_port]/StdCh<1|2|3|4>
RTP
The RTP port is used for transmitting real time audio/video data from
the product. Default is UDP 6970. It can be might not be used in some
environment.
Multicast
The range of Multicast address is 224.0.0.0 ~ 239.255.255.255.
Address
The address is used for multi-casting real time audio/video data from
the product. Default is 224.1.1.1.
Port
The port is used for multi-casting real time audio/video data from the
product. Default is UDP 6970.
TTL
Define number of routers multi-casting data pass through. Default is
0(off).
IP Filtering
You can restrict the access to the admin mode from IP addresses beyond certain IP
address range.
Restrict
Administrator
Access
Check at this box to restrict log on to the admin mode.
Base IP
Address
Input IP address of the PC which is intended to be used for log on to
admin mode.
DynDNS
Setting
You can register the product to the Management Server (DDNS Server) for name
service.
Enable
DynDNS
Enable / Disable DynDNS.
When enabled, you can automatically obtain a domain from DDNS
server by simply registering the network camera product.
DynDNS
Setting
Enable
Anonymous
Enable / Disable DynDNS Anonymous feature.
When enabled, DDNS service is used without going through
authentication at autoipset.com DDNS server.