CNB MDC4050VR - Manual (Page 19)

19
Network Camera_ User manual
Add User
Attribute
You can assign different privileges to users for the access to
system resources.
Attributes are Audio, Bi-directional Audio and Pan/Tilt control.
For example, if you want a specified user to hear the audio
from the device, check Audio in the check box.
User List
You can list “user ids” and “ their attributes” here.
format : user id[A, BA, P] :
A – audio,
BA – bi-directional audio,
P – PTZ(Pan/Tilt/Zoom), attribute.
You can delete specific user by clicking on “DELETE” button.
Authentication
for Viewing
YES
SAVE
If you want to restrict viewing access to the product, check at the
box left to “Yes” and click on “Save”. Users need to input ID and
password to connect to the product in viewing mode.
If No, default
attribute
If you uncheck for the “Authentication for Viewing”, all users
can access the product with the same default attribute. Checked
attributes are enabled. Click “Save” to save the default attribute.
Time Setup
Current Time It shows you the current time kept in the product.
Synchronize with
an Internet Time
Server
Synchronize the time kept in the product with the time kept in
time server on the internet at the right. When the time server is
out of the reach from the product, you can assign time server by
filling in “Specific Time Server” field.
Synchronize With
this Computer
Time
Synchronize the time kept in the product with the time in the PC.
Set Manually Set the time manually. Fill in the fields with desired formats.
SAVE
Save the set-up parameters when parameters settings are
finished. You must click the “Save” once you finish the all
setting-up.
For maintaining more accurate time through continued time synchronization, set the time
synchronization with time server on the network or internet time server.
If ID and Password are lost, you can set the system again torough Factory Default as the
following:
When the power is applied to product, press the Factory Default button for more than 3 sec,
then all Setting Parameters will be returned to Factory Default.