Burkert Type 8035 - Manual (Page 27)

27
Wiring
Type 8025/8035 /
→
Before wiring the device insert the supplied cable clips into the
slots of the electronic board and of the 115/230 V AC power
supply board if the device has such a board.
Fig. 21: Inserting the cable clips
→
Pass the cables through the cable glands.
→
Set the selectors according to chap. "8.3".
→
Connect the terminal block according to the indications of chap.
"8.4.2" to "8.4.6".
8.4.2. Wiring of the relays (versions with
relay output)
Supply
12..36Vdc
FLOW SENSOR
COIL NPN
SOURCE SINK L+ L- PE P- P+ NC
L+ L- PE P- P+ Iout
PULSE
OUTPUT
Without
With Relays
+
-
+
-
2 1
3
PE
• 1: relay 1 connection
• 2: relay 2 connection
• 3: fixation slots
→
Always secure the relays connection cables in the slots marked
(see "Fig. 21").
Fig. 22: Wiring of the relays
English