Burkert Type 8035 - Manual (Page 25)

25
Wiring
Type 8025/8035 /
8.3. configuring the selectors
Only move the selectors when the power supply is off.
→
Before wiring the device, configure the selectors on the elec-
tronic board. See chap. "8.3.1" to "8.3.3".
8.3.1. floW sensor selector
The FLOW SENSOR selector makes it possible to configure the
type of flow sensor: coil or Hall.
For the version with male fixed connector, the selector
is factory-set depending on the output signal of the flow
sensor mounted on the device.
Supply 12..36Vdc
FLOW SENSOR
COIL NPN
L+ L- PE P- P+ NC
L+ L- PE P- P+ Iout
PULSE OUTPUT
Without
With Relays
FLOW SENSOR
COIL NPN PE
Fig. 18: Position of the FLOW SENSOR connector on the
electronic board
Table 2: Positioning of the FLOW SENSOR selector depending on
the output signal of the flow sensor
Version of the
flowmeter output signal of
the remote sensor position of the floW
sensor selector
All Pulse, NPN (hall) NPN
All Sinus (coil) COIL
8.3.2. source/sink selector
The Source/Sink selector makes it possible to set the 4-20 mA
current output of the versions with relays, in sourcing or in sinking
mode. Set the selector depending on the type of wiring.
Supply 12..36Vdc
FLOW SENSOR
COIL NPN
SOURCE SINK L+ L- PE P- P+ NC
L+ L- PE P- P+ Iout
PULSE OUTPUT
Without
With Relays
SOURCE SINK Without
Relays
PE
Fig. 19: Position of the Source / Sink selector
English