Burkert Type 8035 - Manual (Page 20)

20
Wiring
Type 8025/8035 /
1
1 1
1
230V
L N
230V
T 250 mA
5 6 7 8 9 10
L N
230V
NPN SENSOR
1 PULSE INPUT
2 - 3 + 4 NC
SUPPLY
1 2 3 4 PE
3A/230VAC REL1 REL2
FLOW SENSOR
FLOW SENSOR
COIL NPN
CURRENT
SOURCE SINK
COIL SENSOR
1
2 3 NC 4 NC
L+ L- PE P- P+ NC
L+ L- PE P- P+ Iout
PULSE OUTPUT
Without
With Relays
Supply 12..36Vdc
106 mm
106 mm
Fig. 11: Installation of a wall-mounted version
→
Secure the housing to the support respecting the dimensions
indicated in "Fig. 11".
→
Wire acc. to instructions in chap. "8".
→
Close the housing and tighten the 4 screws of the cover.
8. WirinG
danger
risk of injury due to electrical voltage.
• Shut down the electrical power source of all the conductors and
isolate it before carrying out work on the system.
• Observe all applicable accident protection and safety regula-
tions for electrical equipment.
Insert the supplied stopper gaskets into the unused cable
glands of a compact or a wall-mounted version to ensure
the tightness of the device.
Only move the selectors when the power supply is off.
English