Analog Way SmartMatriX Ultra - Manual (Page 48)

48
7.3.16 Control management
In this menu, all specific settings, which can not be sorted under the other menus,are listed.
Network
The web interface loaded into the unit uses the IP configuration.
Under INTERFACE, you can define a new:
- IP address
- Netmask
- Gateway
- Port: Choose the port
- Protocol: Choose TCP (by default) or UDP
Choose DHCP if you want an automatic IP address assignment.
Under the Web RCS feature, you can define the communication Port. You also have an indication on the
number of connected devices.
Emergency presets:
The emergency presets allow you the recall quickly some Master Memo-
ries (see chapter: 7.5 Live / Master memories) . You have the possibility
to have up to 4 emergency memories. Please enable the feature then
choose for each line a master memory which will be recalled in case of
problem.
By enabling the emergency memories, some new buttons will appear
into the live edition:
If you click on A or B, it will recall automatically the MM1 MM2 MM3 or MM4 on the main
screen.
Auto Calibrate
Click on start to launch an auto calibration, in terms of colors, on your analog input/output chips. (See chap-
ter: 11. Maintenance and support)
Erase memories
Into this section, you can erase individual settings.
• Erase input settings memory: All input settings will return to their default value. This includes image, aspect,
user format and keying parameters.
• Erase preset memories: All preset memories will return to their default value.
Factory reset
Click on start to erase all settings (except network and Web RCS parameters). The unit will reboot itself after
the factory reset. Do not forget to refresh your Internet browser by using CTRL+F5. (Clean browser cache.)
7.3.16 Control management