Atec R-S-CMU200 - Manual (Page 37)

Version 09.00, October 2008 R&S ® CMU200 Universal Radio Communication Tester 37
Spectrum emission mask
(SEM application)
Measurement filter receiver filter in line with standard 3.84 MHz, RRC, α = 0.22
Display graphical and numeric values of current,
average and max. values
frequency offset
2.5 MHz to 3.5 MHz 30 kHz
3.5 MHz to 7.5 MHz 1 MHz
7.5 MHz to 8.5 MHz 1 MHz
Resolution bandwidth
8.5 MHz to 12.5 MHz 1 MHz
Measurement interval ≥1 timeslot (2560 chips)
≥1/2 timeslot (1280 chips)
≥1/4 timeslot (640 chips)
≥1/8 timeslot (320 chips)
Power meter (frequency-selective)
7
max. power, min. power bandwidth approx. 7 MHz
off power 3.84 MHz, RRC, α = 0.22
power versus slot bandwidth approx. 7 MHz
Measurement applications
inner loop power 3.84 MHz, RRC, α = 0.22
measurement width 0.25, 0.5, 1 slot
step width 1 slot to 30 slots
step count 1 to 100
Power versus slot
step delay 0 to 100
Level range
continuous power 3 –52 dBm to +47 dBm RF 1
peak envelope power 4 (PEP) –42 dBm to +53 dBm
continuous power –66 dBm to +33 dBm RF 2
peak envelope power 4 (PEP) –56 dBm to +39 dBm
continuous power 8 –89 dBm to 0 dBm RF 4 IN
peak envelope power (PEP) –79 dBm to 0 dBm
Level uncertainty in temperature range +20 °C to +35 °C
–10 dBm to +47 dBm, rms
f < 2200 MHz <0.5 dB
f ≥ 2200 MHz <0.7 dB
–44 dBm to –10 dBm, rms
f < 2200 MHz <0.7 dB
RF 1
f ≥ 2200 MHz <0.9 dB
–24 dBm to +33 dBm, rms
f < 2200 MHz <0.5 dB
f ≥ 2200 MHz <0.7 dB
–60 dBm to –24 dBm, rms
f < 2200 MHz <0.7 dB
RF 2
f ≥ 2200 MHz <0.9 dB
–24 dBm to 0 dBm, rms
f < 2200 MHz <0.5 dB
f ≥ 2200 MHz <0.7 dB
–85 dBm to –24 dBm, rms
f < 2200 MHz <0.7 dB
–83 dBm to –24 dBm, rms
RF 4 IN
f ≥ 2200 MHz <0.9 dB
7 The specified data is valid for RF Attenuation set to Low Noise.
8 Upper limit depends on crest factor.