Atec R-S-CMU200 - Manual (Page 25)

Version 09.00, October 2008 R&S ® CMU200 Universal Radio Communication Tester 25
Modulation analyzer
Level range HPSK, O-QPSK signal
f < 2200 MHz –40 dBm to +44 dBm RF 1
f ≥ 2200 MHz –34 dBm to +44 dBm
f < 2200 MHz –54 dBm to +30 dBm RF 2
f ≥ 2200 MHz –48 dBm to +30 dBm
f < 2200 MHz –80 dBm to –9 dBm RF 4 IN
f ≥ 2200 MHz –74 dBm to –9 dBm
RC1, RC2 (O-QPSK) waveform quality, error vector magnitude,
magnitude error, phase error
Waveform quality ( ρ) uncertainty for ρ 0.9 to 1 <0.003
Frequency measurement range –3 kHz to +3 kHz
f < 2200 MHz <10 Hz + drift of timebase
see base unit specifications Frequency measurement uncertainty
f ≥ 2200 MHz <15 Hz + drift of timebase
see base unit specifications
RC3, RC4 (HPSK) waveform quality, error vector magnitude,
magnitude error, phase error,
channel power, code domain power,
peak code domain error power
Waveform quality ( ρ) uncertainty for ρ 0.9 to 1 <0.003
Frequency measurement range –3 kHz to +3 kHz
Frequency measurement uncertainty <10 Hz + drift of timebase,
see base unit specifications
Relative measurement uncertainty result > –33 dB <0.1 dB
Measurements
Modulation overview
EVM versus time, graphical
ME versus time, graphical
PE versus time, graphical
I/Q analyzer
Power standby/access-probe power
open loop time response
gated output power
max. output power
min. output power
power versus frame
smart alignment
narrowband power
Spectrum adjacent channel power
Code domain power code domain power
code domain error power
channel power
time/phase offset relative to pilot
Receiver FER for FCH, SCH
RLP/throughput statistics
forward power control
R&S
®
CMU-B85 speech codec option
Speech decoder output SPEECH HANDSET OUT 9-pin D-Sub connector
Output impedance <10 Ω
Max. output current 20 mA, peak
Full-range output level 1 V, peak
Speech coder input SPEECH HANDSET IN 9-pin D-Sub connector
Input impedance 100 k Ω
low sensitivity 1.4 V, peak Full-range input level
high sensitivity 0.1 V, peak