Atec R-S-CMU200 - Manual (Page 34)

34 R&S ® CMU200 Universal Radio Communication Tester Version 09.00, October 2008
Influence on RF interface
Reduced input level range if R&S ® CMU-B96 is installed
RF 1 continuous input power max. 2 W
RF level uncertainty Use of the R&S ® CMU-B96 in overrange
mode may influence all RF signal levels
and quality.
RF analyzer (TX measurements)
non-signaling mode Frequency range
698 MHz to 716 MHz
777 MHz to 798 MHz
824 MHz to 849 MHz
880 MHz to 915 MHz
1427.9 MHz to 1452.9 MHz
1710 MHz to 1785 MHz
1850 MHz to 1910 MHz
1920 MHz to 1980 MHz
2000 MHz to 2020 MHz
2500 MHz to 2570 MHz
signaling mode
band 1 1920 MHz to 1980 MHz
band 2 1850 MHz to 1910 MHz
band 3 1710 MHz to 1785 MHz
band 4 1710 MHz to 1755 MHz
band 5 824 MHz to 849 MHz
band 6 830 MHz to 840 MHz
band 7 2500 MHz to 2570 MHz
band 8 880 MHz to 915 MHz
band 9 1749.9 MHz to 1784.9 MHz
band 10 1710 MHz to 1770 MHz
band 11 1427.9 MHz to 1452.9 MHz
band 12 698 MHz to 716 MHz
band 13 777 MHz to 787 MHz
band 14 788 MHz to 798 MHz
Frequency range
band S 2000 MHz to 2020 MHz
Frequency offset –100 kHz to +100 kHz
Frequency resolution 1 Hz
Frequency setting by channel number or frequency
Level setting by autoranging or manual mode
Max. level setting range
RF 1 peak envelope power 4 (PEP) –38 dBm to +53 dBm
RF 2 peak envelope power 4 (PEP) –52 dBm to +39 dBm
RF 4 IN peak envelope power (PEP) –77 dBm to +0 dBm
Statistics
Statistic count 1 to 1000
Values current, average, min./max.
Trigger non-signaling mode
Trigger sources free run, internal, external, IF power, slot,
frame, TPC, HSDPCCH, auto
Trigger input 15-pin D-Sub connector AUX 3, pin 8 external
Trigger slot delay 0 to 14 slots
Trigger delay offset –10239 to + 10239 × 1/4 chip
Trigger output 15-pin D-Sub connector AUX 3, pins 2 to 5 frame, slot, TPC, HSDPCCH