Atec Agilent-16700 Series - Manual (Page 113)

113
Pattern Generation Modules Specifications
and Characteristics
[1] Typical skew measurements made at pod connector with approximately 10 pF/50 K Ω load to GND; worst case
skew numbers are a calculation of worst case conditions through circuits. Both numbers apply to any channel
within a single or multiple module system.
[2] Channel 7 on the 3-state pods has been brought out in parallel as a non 3-state signal. By looping this output back
into the 3-state enable line, the channel can be used as a 3-state enable.
Agilent 10465A ECL Data Pod (unterminated)
Output type 10H115 (no termination)
Maximum clock 300 MHz
Skew [1] typical < 1 ns; worst case = 2 ns
Recommended lead set Agilent 10347A
Agilent 10466A 3-State TTL/3.3 volt Data Pod
Output type 74LVT244 with 100 Ω series; 10H125 on non 3-state channel 7 [2]
3-state enable negative true, 100 K Ω to GND, enabled on no connect
Maximum clock 200 MHz
Skew [1] typical < 3 ns; worst case = 7 ns
Recommended lead set Agilent 10474A
10H115
100 Ω
74LVT244