Alpha Technologies GMX-915 - Manual (Page 24)

2 017-932-B0-002, Rev. B
If you are using an Alpha SPI, procede to Section 3.3. For AC output voltage reconfiguration see Section 4.2,
otherwise continue to Section 5.1, Start-up and Test. DO NOT switch on the Inverter Battery Breaker, or apply
AC power to the power supply at this time.
3.0 Installation, continued
3.2
Installing the optional AC Indicator Lamp, continued
5. Connect the shorter black/white set of wires to the black/white wires leading from the SPI.
Connect the remaining longer set of wires to the V
out
± terminals on the front of the GMX
Power Supply (see Fig. 3-3). Connect the black wire to the positive terminal. Connect the
remaining wire (white, yellow, or blue) to the negative terminal.
Fig. 3-3, ACI Connection
NOTE:
Black Wire (Positive)
White, Yellow or Blue Wire (Negative)
+
AUX
OUT
–
+
LRI
–
+
V OUT
–
GND
87V
63V
SEL
V