Alpha Technologies GMX-915 - Manual (Page 23)

23 017-932-B0-002, Rev. B
The AC indicator (green lamp) is located on the outside of the enclosure. When the lamp
is on, it indicates AC power is available at the power supply output. This enables service
personnel to determine the status of the power supply without having to climb the pole.
Installation Procedure:
1. Remove rear-most knockout.
2. Feed ACI wires through hole.
3. Slide locking nut over wires, and thread onto lamp body (see Fig. 3-1).
. Insert the crimped contacts on the short set of wires into the plastic connectors. The black
wire must always go into the black connector. Insert the remaining wire (may be white,
yellow, or blue in color) into the white connector (see Fig. 3-2).
Fig. 3-2, Wire/Connector Assembly
White Connector
Black Connector Black Wire
Top View
White, Yellow, or Blue Wire
Verify contact
snaps over metal
retainer
Side View
3.0 Installation, continued
3.2 Installing the Optional AC Indicator Lamp
If the system configuration includes an ACI option, install per the following instructions.
NOTE:
To remove a wire from a plastic connector, depress the metal retainer with the Anderson insertion/extraction
tool, (Cat. Number 111038G2), and slide the wire out.
NOTE:
Verify that the contact is secure. Failure to properly position the contact will result in overheating,
and cable assembly failure.
CAUTION!
Fig. 3-1, AC Indicator
Enclosure Wall
Nylon Washer
To SPI To V
out
± Terminals