Franklin Fueling Systems T5 Series Fuel Management System Operators Guide - Manual (Page 7)

3
Introduction
The purpose of this manual is to guide installers, operators and technicians through the operation of a T5 series console.
The T5 series consoles incorporate the monitoring and alarm capabilities of preceding automatic tank gauges with
advanced technologies to supply tank and level data more accurately and efficiently. This manual is also designed to
introduce technicians to the optional LCD Graphical User Interface, which is used as an input device to program system
configuration and maintain all applications from the front panel of the console. Overall safety issues, troubleshooting
information, start-up procedures, warranty, service and return policies, as defined in this manual, must be followed.
The TS-5 (TS-608) / 550 / 5000 Fuel Management System consists of an open architecture, modular console that can
run multiple Fuel Management Applications simultaneously. It typically contains an LCD touch screen user interface and a
built-in printer, but it can also be operated by a web-based remote interface. Magnetostrictive Liquid Level Probes inside
of the tanks provide the console with inventory and leak detection information. A variety of optional sensors can be used
to monitor containment spaces. T5 series consoles combine the power and flexibility of computer-based open architecture
with a high speed modular bus design.
Note: The TS-5 (TS-608) comes standard with an LCD touch screen display and does not accommodate for an internal
printer. An internal printer and touch screen display are optional on all other systems.
Definitions and Acronyms
TS-2WSNS – 12 input, 2-Wire Sensor Module (Intrinsically Safe)
TS-3WSNS – 8 input, 3-Wire Sensor Module (Intrinsically Safe)
TS-ACI – 12 input, AC Input Module
TS-420IB – 4-20mA Analog Input Module (Intrinsically Safe)
AST – Aboveground Storage Tank
CARB – California Air Resources Board
TSSP-CM – Controller Module
Console – The enclosure that houses the Modules.
DHI – Dispenser Hook Isolation
TS-DIMIB – Dispenser Interface Module
DW/DWT – Double Wall/Double Wall Tank
EVR – Enhanced Vapor Recovery
FMS – Fuel Management Systems
IS – Intrinsically Safe
LCD – Liquid Crystal Display
LON – Echelon Communication Module
LLD – Line Leak Detection
Module – A plug-in card within a T5 series console that is used to perform various functions for a console. Modules are
used for field wiring the input and/or output of electrical signals between different functional equipment pieces.
NWGLDE – The National Work Group Leak Detection Evaluations
PC – Personal Computer
TS-PRB – Probe Module (Intrinsically Safe)
TSSP-PS – Power Supply Module
RS-232 – An EIA standard for serial communication using either a 9 or 25-pin connector or adapter.
RS-485 – An EIA standard for serial communication.
RTD – Resistance Temperature Detector
RJ-45 – An EIA standard connector for use in communications with an eight conductor cable. Usually used in data
transmission applications.
RJ-11 – An EIA standard connector for use in communications using STP wiring. Usually used in voice and fax
applications.
TS-RLY – Relay Module
STP – Submersible Turbine Pump
TPI – Turbine Pump Interface
TS-EMS – Environmental Monitoring System
TS-EXPC – Expansion Console
USB – Universal Serial Bus
UST – Underground Storage Tank
VRM – Vapor Recovery Monitoring
XML – eXtensible Markup Language