Appendix 3: 3-wire sensor module (3wsns), Figure 3-1 – 3-wire sensors connections – Franklin Fueling Systems T5 Series Fuel Management System Installation Guide User Manual
Page 26

26
Appendix 3: 3-Wire Sensor Module (3WSNS)
The 3-Wire Sensor Module (3WSNS) is designed to accept 8
sensor inputs per module, and the system as a whole can accept
a total of 24 sensors (3 modules with 8 inputs each). The 3WSNS
can support standard sensors and
BriteSensors
®
.
BriteSensors
are powered sensors that digitally communicate the sensor–type
and alarm status of the sensor to the console. Most BriteSensors
can discriminate between water and hydrocarbon products and
produce different alarm codes for each.
Refer to the diagram
below to identify the types of sensors that should be used with this
module.
Important: Brite Sensors are not approved for use in European Union markets where ATEX approved devices are
required.
Most of the Brite Sensors shown in this table are part of the UL & C-UL System Listing.
Model
Description
TSP-EIS
Electro-optical Interstitial liquid – Standard sensor
TSP-ULS
Universal Liquid – Standard sensor
TSP-HLS-15
High product Level, 15" – Standard sensor
TSP-HLS-30
High product Level, 30" – Standard sensor
TSP-HIS
Hydrostatic Interstitial reservoir – BriteSensor
TSP-HIS-XL*
Hydrostatic Interstitial reservoir, extra long – BriteSensor
TSP-DIS
Discriminating Interstitial liquid – BriteSensor
TSP-DDS
Discriminating Dispenser Sump – BriteSensor
TSP-DTS
Discriminating Turbine Sump – BriteSensor
TSP-DVS*
Discriminating Vapor – BriteSensor
TSP-MWS
Discriminating Monitoring Well – BriteSensor
* TSP-HIS-XL and TSP-DVS sensors are not covered by UL and cUL approval.
Note: Alternate sensors may be provided. All components located in the hazardous area must be Third Party Certified
and have appropriate Entity Parameters (see Control Drawing 000-1722 in the back of this manual for further
information).
3-Wire Sensor Module
Number of Channels: 8
Safety Rating:
Class I, Division 1, Group D, [Ex ia] IIA
Entity Parameters
Uo = 7.71 V
Io = 573 mA
Co = 500 uF
Lo = 433 uH
Po = 932 mW
3-Wire Sensor
Module
RUN
ERR
4
–Blk
Wht
+Red
3
–Blk
Wht
+Red
2
–Blk
Wht
+Red
1
–Blk
Wht
+Red
8
–Blk
Wht
+Red
7
–Blk
Wht
+Red
6
–Blk
Wht
+Red
5
–Blk
Wht
+Red
- (BLK)
+ (RED)
(WHT)
TSP-DTS
(Discriminating Turbine Sump)
- (BLK)
TSP-ULS
(Universal Liquid Sensor)
(WHT)
TSP-EIS
(Electro-optical Interstitial sensor)
- (BLK)
+ (RED)
(WHT)
Figure 3-1 – 3-Wire Sensors Connections