Franklin Fueling Systems Colibri CL6 Setup and Operators Guide - Manual (Page 9)

9
[Setup] / Dispenser Interface
Note: The Dispenser Interface allows the console to read dispensing information and requires the TS-TRAC option.
Dispenser information is sent through the Serial Port.
Parameter
Name
Parameter Name Parameter Value Description Max Value
Grades Number of grades (0) The number and name of products used at the site.
(0-32)
Fueling Points Number of fueling
points
(0) Anywhere on site where a vehicle can get fueled.
(0-32)
Hoses Number of hoses (0) The number of grades available at a specific fueling point
(0-8)
Dispenser Interface: Example of site set-up
There are 4 grades in this example:
• Unleaded
• Mid-grade
• Premium
• Diesel
Dispenser 1 Dispenser 2
FP1
FP2
FP3
FP4
U M P U M P D
U = Unleaded
M = Mid-Grade
P = Premium
D = Diesel
U = Unleaded
M = Mid-Grade
P = Premiuml
Dispenser 1 Dispenser 2
FP = Fueling Point
There are 3
grades available
at Fueling Points
1 and 2. Number
of hoses = 3
There are 4
grades available
at Fueling Points
3 and 4. Number
of hoses = 4
Site Top View Dispenser Detail View
To Setup Dispensing Information:
1. Connect the RS232 serial cable from the distribution box (D-box) to the RS232 port on the Colibri.
2. Verify that the RS232 Communication port settings on the console match the D-box communication settings.
Refer to Page 6 of this manual for Serial Port Setup options.
3. On the Colibri console, enter the number of grades. For this example (page 10), there are 4 grades.