Franklin Fueling Systems Colibri CL6 Setup and Operators Guide - Manual (Page 12)

12
[Setup] / Fuel Management System / Static Tank Testing
Parameter Name Parameter Value Description Value
Region United States Choose United States, Spain or Other (regulatory) abc#
Monthly Leak Test
Threshold
(0.21) Set static leak tolerance for monthly testing tanks. # cc/sec
Yearly Leak Test
Threshold
(0.11)
Set static leak tolerance for yearly testing tanks.
# cc/sec
Sentinel Mode
Threshold
(3.15)
Set static leak tolerance for Sentinel Mode.
# cc/sec
Confidence (99%) Leak testing confidence. 90, 95, 97.5,
99 %
Minimum Leak Test
Time
(2 hr)
Minimum amount of time used to test.
0-8
Maximum Leak Test
Time
(8 hr)
Maximum amount of time used to test.
1-8
Alarm On Precision
Leak Test Failure
(No)
Yes will produce an alarm upon leak test failure.
Yes/No
[Setup] / Fuel Management System / Tanks
Parameter Name Parameter Value Description Value
Name (Tank 1) Given name of tank. abc#
Type (Special 1) Type of tank. Std./Spcl.
Manifolded (No) Part of a tank Manifold? Yes / No
Product # (1) Product # In tank 1-48
Delivery Threshold (757.1 liter) Level increase needed to signal delivery >0.3
Theft Threshold (18.9 liter)
Level decrease needed to signal theft. Note: console
must be in Sentinel Mode
>0.3
Monthly Compliance Yes
Track this tank under monthly section of compliance
page.
Yes / No
Annual Compliance Yes
Track this tank under annual section of compliance
page.
Yes / No
Probe (See below)
Limits (See below)
[Setup] / Fuel Management System / Tanks /
Tank 1 / Probe
Parameter
Name
Parameter Value Description Value
Channel (Probe 1) Channel used for the probe in tank. Probe
Type (Standard 29) Type of probe used in this tank. Std./Spcl.
Ratio (1 to 1 tip to head) Ratio of product level movement in proportion to
the float
1:1; 7:1; 9:1
Float Type (4 in gas) Type of float(s) used on probe. 4, 3, or 2 in.
Gas/Diesel,
Stainless,
LPG, Density
Water Float Yes Indicates if water float is on probe. Yes / No
Gradient (8.99046 µs/mm) Speed of probe wire. # µs/mm
Product Offset (0.00 mm) Used for compensation of tank tilt. # mm
Water Offset (0.00 mm) Used to compensate for debris on tank bottom. # mm