Franklin Fueling Systems Colibri CL6 Setup and Operators Guide - Manual (Page 8)

8
Entering Setup
Always enter information starting from the top of the menu. Later menus use this information.
Note that the tables are formatted to correspond to the Web Browser Interface. Information shown is also valid for the
LCD touch screen.
[Setup] / System ID
Parameter Name Parameter Value Description Max Characters
Site Name (Site Name) Name of site. 40
Web UI URL (http://localhost/tsa) URL address of site. 40
ID Line 1 (blank) These lines should contain the physical address of the site. This
information is used in reports and to identify site properties when
using Web User Interface.
40
ID Line 2 (blank) 40
ID Line 3 (blank) 40
ID Line 4 (blank) 40
ID Line 5 (blank) 40
[Setup] / System Configuration
Parameter Name Parameter Value Description Value
Technical Support
Key
(0) Enter the appropriate key number. #
Enable Log Files (No) Enables the logging option. Yes/No
Note: The System Configuration entries are for use by Franklin Fueling Systems for diagnostic purposes.
[Setup] / Probe Modules
Parameter Name Parameter Value Description Value
Module # Channels (0)
Number of channels in use per
module.
1-6
Channel # Name (Probe 1) Given Name of Probe. abc#
(30 characters
maximum)
[Setup] / Relay Modules
Parameter Name Parameter Value Description Value
Module # Channels (2) Number of channels in use per module. 1 or 2
Channel # Name (Relay 1) Given name of the channel. abc#
(30 characters
maximum)
Enabled (Yes) Yes if the channel is in use. Yes / No
Polarity (Normal) Allows the polarity to be inverted. Normal, Invert
Physically Wired As (Normally Open) How the relay is wired internally. NO, NC