Extron Electronics System 8_10 Plus - Manual (Page 30)

Extron • System 8/10 P
LUS
• User’s Manual
Projector/Monitor Installation
3-1
Projector/Monitor Installation
The System 8/10 Plus can be configured for many projectors. Among the
projector manufacturers which Extron supports are:
• Ampro • NEC/Runco
• Barco • Panasonic
• Digital Projection • Sanyo
• Eiki • Seleco
• Electrohome • Sharp
• Epson • Sony
• Hughes/JVC • Toshiba
• InFocus • Zenith
• Mitsubishi
_____ If your projector manufacturer is not listed here, please consult with Extron.
Extron System 8/10 P LUS switchers have bidirectional (i.e., "talk-listen"), user-
programmable communications that communicates with the displays listed
above. If projector input selection is made by the hard-wired or infrared remote
control of the display*, the System 8/10 P
LUS switcher "listens" to the selection
and switches to the proper input.
When an input selection is made at the switcher (by a front panel button, hard-
wired remote control, RS-232 communications or IR-30), the System 8/10 P
LUS
switches the projector to RGBS, S-Video, or Composite (as required) and
commands the projector to load the pre-programmed presets for that input.
* not applicable on some displays
General