Extron Electronics PowerCage FOX Tx_Rx HDMI User Guide - Manual (Page 38)

Advanced tab functions
Click the Advanced tab to access the functions described below.
NOTE: The Advanced functions are available only if your computer is connected to the
receiver.
Advanced Configuration area
Link 2 and Daisy Chain radio buttons —
Select among the Enable Link 2,
Disable Link 2, and
Enable Daisy Chain radio buttons to
define the function of the receiver Tx LC
connector; either:
• Routing RS-232 over fiber to the transmitter
• No function
• Routing the signal received on the Rx LC connector to the next receiver in a daisy chain.
NOTE: The disable return link function is primarily used and recommended when the
transmitting device is a FOX 500 DA6 and the receiver is connected to any of
outputs 2 through 6 on the DA.
Auto Memory radio buttons — Select the Auto Memory radio button to automatically
apply saved position settings when the sensed input resolution changes.
Test Patterns drop box — Select one of three built-in test patterns; Colorbars,
Grayscale, and Alternating Pixels; as necessary to help adjust the color,
brightness and contrast, and focus of the display. Select Off to output the video that is
input to the transmitter.
NOTES: • You must have a video input connected, the transmitter-Tx-to-receiver-Rx
fiber cable connected, and the receiver cannot be in daisy-chain mode for the
receiver to output a selected test pattern.
• The test pattern turns off if the input signal rate is changed or disconnected
or if power is removed.
PowerCage FOX HDMI • Remote Control 32