Extron Electronics PowerCage FOX Tx_Rx HDMI User Guide - Manual (Page 36)

I/O Configuration tab functions
Click the I/O Configuration tab to access the functions
described below.
Output Configuration area
NOTE: The Output Configuration area control is available only
if your computer is connected to the receiver.
The Video Shutdown Delay setting delays the digital video to help monitors sync correctly
during an input rate change. Only video is delayed; embedded audio is not delayed.
HDCP area
NOTE: • The HDCP Authorized controls are available only if
your computer is connected to the transmitter.
• The HDCP Notification controls are available only if
your computer is connected to the receiver.
Both sets of radio buttons cannot be available for
selection at the same time.
HDCP Authorized radio buttons — The HDCP Authorized setting allows a user to turn
off HDCP communication on a discrete input. This setting is useful for devices such as Mac
computers, iPhones, iPads, and some Windows 7 sources that always encrypt their output
if the downstream sink is capable of HDCP. By not allowing HDCP signals on an input, most
content from these sources can be passed as a non-encrypted signal to analog and digital
video outputs. In a video system that has requirements to not transmit HDCP encrypted data
(such as non-HDMI FOX Extenders), HDCP support should be turned off at the input to keep
the non-HDMI output of the FOX Extender unencrypted.
HDCP Notification radio buttons — The HDCP notification function in the receiver
enables a connected display to show a green or black screen if the transmitted HDMI video is
HDCP encrypted and the display is not HDCP capable.
PowerCage FOX HDMI • Remote Control 30