Extron Electronics PowerCage FOX Tx_Rx HDMI User Guide - Manual (Page 34)

Status area
Figure 16. Status Area
The status area provides indications of the connection status.
• HDMI indicator — This indicator is green when the transmitter detects a sync signal on
its HDMI video input
• Audio indicator — This indicator is green when the transmitter detects a low level
audio signal for a short period. This indicator goes dark if the audio signal drops below
the minimum threshold for a short period.
• Link 1 indicator — This indicator is green when the receiver detects light on the fiber
optic cable connected to the Tx port.
NOTE: The receiver detects the transmitter-Tx-to-receiver-Rx light. It reports the
status to the transmitter via the optional Rx cable.
If the PC is connected to the transmitter and either the secondary (receiver-
Tx-to-transmitter-Rx) cable is not connected in your system or the receiver
is in the daisy chain mode, the Link 1 indicator in the control program
does not show green (detected), whether the receiver detects the link or not.
• Link 2 (Optional) indicator — This indicator is green when the transmitter detects
light on the fiber optic cable connected to the Rx port.
NOTE: The transmitter detects the receiver-Tx-to-transmitter-Rx light. It reports the
status to the receiver via the Tx cable.
If the PC is connected to the receiver and either the primary (transmitter-
Tx-to-receiver-Rx) cable is disconnected or the receiver is in the daisy chain
mode, the Link 2 indicator in the control program does not show green
(detected), whether the transmitter detects the link or not.
The Status area also shows to which unit the controlling PC is connected, the FOXBOX
model (multimode or singlemode), the internal temperature, and the video input frequency.
The Other Side entry cannot be read on the FOXBOX HDMI and shows N/A.
PowerCage FOX HDMI • Remote Control 28