Extron Electronics IN1508 User Guide - Manual (Page 65)

Command/response Table for SIS Commands (continued)
Command ASCII Command
(Host to Unit)
Response
(Unit to Host)
Additional Description
DVI auto-detect (input 8 only)
NOTE: When DVI auto-detect is enabled, the horizontal start and vertical start adjustments are disabled. If you need to change these
settings, disable DVI auto-detect.
Disable DVI auto detect 0*76# DVI80 ] Disable the auto adjust feature (allow the
user to set horizontal start and vertical
start).
Enable DVI auto-detect 1*76# DVI81 ] Allow the IN1508 to auto adjust the DVI
settings (default).
Read DVI auto-detect 76# DVI8 X$] X$ : 0= disable, 1 = enable (default).
IN1508 • Programming Guide 60