Extron Electronics IN1508 User Guide - Manual (Page 17)

NOTES: • If any of the rates not available from the front panel are selected using
the menu system or SIS commands, no Output Rate LED is lit.
• The Output Rate button allows you to select the resolution only; the
refresh rate defaults to 60 Hz for each front panel resolution selection.
You can select a different refresh rate using the menu system; see
“
Refresh Rate selection box ” on page 29 for details.
• There is a 1-second delay between selecting an output resolution from
the front panel (the desired Output Rate LED lights) and the selected
change taking effect. This ensures that the screen does not try to change
resolutions while you cycle through the available resolutions to the
desired setting.
The switcher reports the selected resolution for approximately 3 seconds on the
connected output display.
Picture-in-Picture Controls
d PIP buttons —
PIP
ON SWAP
Figure 11. Picture-in-Picture Buttons
On button — The PIP On button toggles the PIP function on and off.
NOTES: • If you press and hold the PIP On button while you apply power to the
switcher, the switcher toggles the output signal type between RGB and
progressive component video. If an RGB signal type (RGBHV, RGBS, or
RGsB) was selected the last time the switcher was powered, the signal
type switches to component. If component video was selected, the signal
type switches to RGB.
• The audio breakaway and video breakaway switching functions, normally
available under RS-232 control only, is not available when the PIP
function is on.
On LED — When lit, the PIP On LED indicates that the PIP function of the switcher is on.
Swap button — The PIP Swap button toggles the primary and secondary pictures
between the main image and the PIP window.
IN1508 • Operation 12