Extron Electronics IN1508 User Guide - Manual (Page 59)

Command ASCII Command
(Host to Unit)
Response
(Unit to Host)
Additional Description
Input selection and PIP swap
Select video and audio input X! ! Chn X!] Select video and audio input X! .
Example: 2! Chn02 ] Select video and audio input 2.
View video and audio input ! Chn X!] Input X! is selected.
Swap PIP and main windows % Pch X!] X! is the input in the PIP window.
Audio/video breakaway switching
NOTE: Audio/video breakaway switching is only available when the PIP function of the switcher is off (the front panel PIP On LED is unlit).
The switcher responds with an E10 error if the PIP On is lit (the PIP function is active.
Switch audio input X! $ In X! •Aud ] Select audio input X! .
Switch video input X! & In X! •Vid ] Select video input X! .
Auto-Image (inputs 6 and 7 only)
Execute Auto-Image A Img ] Center the window, set the window size to the
current output resolution, and set horizontal and
vertical start and active pixels and active lines.
Switcher output video resolution
Set output resolution and rate X@ * X@ = Rte X@ * X#] Command character is “equals”.
Example: 5*3= Rte5*3 ] Set the output to 1024x852 at 75Hz.
View resolution and rate = Rte X@ * X#]
Video mute
Set video mute on 1B Vmt0 ] Set the video output to black.
Set video mute off 0B Vmt1 ] Set the video output to the selected input 1
through 8.
View video mute status B Vmt X$] Video mute is X$ (on or off).
Color
NOTE: Color adjustments are available only for inputs 1 through 4. If input 5 is configured as interlaced component video, its color can
also be adjusted. Color adjustments are made to the selected input only.
Set a specific color value X^ C Col X^] Specify the color adjustment.
Increment color value +C Col X^] Increase the color setting by one.
Decrement color value –C Col X^] Decrease the color setting by one.
View the color value C Col X^] Show the color setting.
Tint
NOTE: Tint adjustments are available only for inputs 1 through 4. Tint adjustments are made to the selected input only.
Set a specific tint value X^ T Tin X^] Specify the tint adjustment.
Increment tint value +T Tin X^] Increase the tint setting by one.
Decrement tint value –T Tin X^] Decrease the tint setting by one.
View the tint value T Tin X^] Show the tint setting.
Brightness
Set a specific brightness value X^ Y Brt X^] Specify the brightness adjustment.
Increment brightness value +Y Brt X^] Increase the brightness setting by one.
Decrement brightness value –Y Brt X^] Decrease the brightness setting by one.
View the brightness value Y Brt X^] Show the brightness setting.
NOTE: X! = Input number 1 through 8
X@ = Resolution (EDID) See page 53 .
X# = Video refresh rate 0 = Match output (EDID only)
1 = 50 Hz 3 = 75 Hz (24 Hz for 1080p)
2 = 60 Hz 4 = 59.94 Hz
X$ = Mute status 0 = mute off 1 = mute on
X^ = Picture adjustment range 000 through 128
Command/Response Table for SIS Commands
IN1508 • Programming Guide 54