Extron Electronics IN1508 User Guide - Manual (Page 41)

NOTE The and buttons toggle between the top and bottom selection where applicable.
The and buttons move the slider on the selected status bar indicator.
No
menu
display
= IR remote control
ASPECT
RATIO
Sharpness
Aspect Ratio 4:3
+32
(0 to 63) SHARP
PHASE
Phase +64
(0 to 128)
Zoom
Pan
Sharpness
Aspect Ratio 4:3
Phase
Zoom
Pan
V
H
Timeout
Timeout
Timeout
ZOOM
PAN
Timeout
Timeout
Press to change
the aspect ratio.
Figure 28. Picture Adjustments Flowchart, IR Remote Control
• Size: The Size button calls one of three displays, depending on whether PIP mode is
on or off.
PIP is on — Size displays a single status indicator bar that allows you to cycle
through the 1/4, 1/9, 1/16, and 1/25 sizes of the PIP window. Use the and
buttons to cycle through the options.
This adjustment is also available by using the front panel or IR remote control to
select Menu > Advanced > PIP Mode in the main menu system (see “
PIP Mode
selection box ”, on page 32).
PIP is off — Size toggles between the Image Size display and the Window Size
display.
Image Size display — This display consists of the Active Pixels, Active lines,
and Phase status indicator bars, which are advanced adjustments that should be
attempted only by knowledgeable A/V professionals (see “
Active Pixels and
Active Lines status indicator bars ” on page 43 and “ Phase status indicator
bar ” on page 45).
Window Size display — This display consists of two status indicator bars that
show, and allow you to adjust, either the position (centering) of the main image
or position of the PIP window, depending on whether the PIP feature is off or on.
The adjustment range depends on the input rate applied and the output resolution
selected.
This adjustment is also available by using the front panel or IR remote control to
select Menu > Input > Size in the main menu system (see “
Size selection ”, on
page 25).
IN1508 • Operation 36