Extron Electronics DXP HDMI User Guide - Manual (Page 83)

DXP DVI Pro and DXP HDMI Series • Matrix Software 77
Managing Ties
On the matrix window, you can create, dissolve, and view input-to-output ties as follows:
• To create a tie, click and drag from an input box to an output box.
• If Hold/Verify Changes has been selected from the Preferences menu:
A broken line appears, connecting the two boxes. If you want to undo the
preliminary tie at this point, click the
Cancel button. The broken line disappears.
Click Take to confirm the tie. The broken line becomes solid.
• If Immediate Changes has been selected from the Preferences menu:
The tie is made immediately. No Cancel button is displayed.
• To create a quick multiple tie, drag the desired input box to the word “ Out ” above
the output column. The input is tied to all the outputs, replacing any existing ties.
• To remove a tie, drag the output box to its tied input box or to the trash can.
•
If Hold/Verify Changes has been selected from the Preferences menu:
The tie line becomes broken. If you want to reinstate the tie at this point, click
Cancel . The broken line becomes solid again. Click Take . The broken tie line
disappears.
• If Immediate Changes has been selected from the Preferences menu:
The tie is undone immediately.
• To view information on a specific input or output device, position the cursor
over that device in the matrix window. A pop-up window opens, showing the input
and output numbers, names (if captions were specified), details on the connections to
that device, and the frequency of the video signal being sent to or from it.
Figure 77. Matrix Window with Pop-up Information on Audio Input 1