Extron Electronics DXP HDMI User Guide - Manual (Page 79)

DXP DVI Pro and DXP HDMI Series • Matrix Software 73
Fig_Comm port sel window
Figure 70. Comm Port Selection Window
2. Choose the communication port through which the DXP is connected to the
computer:
• If you selected a Comm port, check the baud rate displayed in the Comm Port
Selection window. To change the baud rate, click the
Baud button to display the
baud rate pop-up list. (After you click it, this button changes to OK .) Double-click
on the desired baud rate (available rates are 9600, 19200, 38400, and 115200;
the default is 9600), then click
OK and proceed to step 4.
Figure 71. Baud Rate Pop-up List
• If you selected IP [LAN] , click OK and proceed to step 3.
• If you selected Emulate , click OK and see “ Using Emulation Mode ” on
page 98.