Extron Electronics DXP HDMI User Guide User Manual
Page 70
DXP DVI Pro and DXP HDMI Series • SIS Configuration and Control
64
Command
ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Information Requests (continued)
Firmware Version Queries:
NOTE:
There are up to three separate sets of Extron firmware on which the switcher can report: the controller firmware,
which is the overall control firmware; the Ethernet protocol firmware, which handles the Ethernet interface; and
the latest optional Extron firmwar
.
Query controller firmware
version
Q
X2!]
View firmware version
X2!
to
the second decimal place.
Example:
Q
1.23
]
The factory-installed controller
firmware version is 1.23.
Query controller firmware
version (verbose)
0Q
X2!
–
X2@
–
X2@]
Provide a detailed status
of the Ethernet protocol
firmware, the controller
firmware, and any firmware
upgrade. The firmware that
is running is marked by
an asterisk (*). A caret (^)
indicates that the firmware has
a bad checksum or an invalid
load. ?.?? indicates that
firmware is not loaded.
Example:
0q
(See below.)
Ethernet
Protocol
Firmware
Response:
Description
DXP Firmware Version
Updated Firmware Version
* Indicates the Version Running
Upload Date and Time
3.03-1.13(1.81-DXP Series -Wed, 16 Jan 2003 00:00:00 GMT)-1.13*(1.81-DXP Series -Thu, 02 Sep 2011 18:42:05 GMT)
Request system status
S
X1^
•
X1^
•
X1&
•
X1*
•
X$]
Display voltages
X1^
, internal
temperature
X1&
, fan speed
X1*
(rpm), and power supply
status
X$
.
Example:
S
3.29•4.85•+077.80•03750•1
Power supply
is on and Ok.
Fan 1 rotating
at 3750 RPM
5 V Power System
at 4.85 V
3.3 V Power
System at 3.29
Internal
Temperature
NOTE:
X$
= Power supply status
0 = not OK, 1 = OK
X1^
= Voltage
Positive or negative voltage and magnitude of internal power supplies
X1&
= Temperature
Degrees Fahrenheit
X1*
= Fan speed
In
RPM
X2! = Firmware version number
To second decimal place (
n.nn
)
X2@ = Verbose firmware version
Version–description–upload date and time