Extron Electronics DXP HDMI User Guide - Manual (Page 13)

DXP DVI Pro and DXP HDMI Series • Installation 7
NOTE: The illustration on the previous page shows a DXP 88 HDMI, with eight
HDMI input connectors and eight HDMI output connectors. The rear panels
of the other three DXP HDMI models are identical to this model except for the
number of inputs and outputs:
• DXP HDMI 84 – 8 inputs and 4 outputs
• DXP HDMI 48 – 4 inputs and 8 outputs
• DXP HDMI 44 – 4 inputs and 4 outputs
a
AC power connector — Plug a standard IEC power cord into this connector to
connect the switcher to a 100 VAC to 240 VAC, 50-60 Hz power source.
b
Input connectors —
• DVI Pro series: Connect DVI-D source devices to these female 29-pin DVI-I
input connectors. Only single-link DVI-D signals are supported.
8 Not used 16 Hot plug 24 TMDS clock–
detect
Pin Signal Pin Signal Pin Signal
1 TMDS data 2– 9 TMDS data 1– 17 TMDS data 0–
2 TMDS data 2+ 10 TMDS data 1+ 18 TMDS data 0+
3 TMDS data 11 TMDS data 1/3 19 TMDS data 0/5
2/4 shield shield shield
4 Not used 12 Not used 20 Not used
5 Not used 13 Not used 21 Not used
6 DDC clock 14 +5 V power 22 TMDS clock
shield
7 DDC data 15 Ground 23 TMDS clock+
1 8
17 24 9
Female DVI Connector
Figure 5. DVI Connector Pin Assignments
• HDMI series: Connect HDMI source devices to these female 19-pin type A
HDMI input connectors.
Pin Signal Pin Signal Pin Signal
1 TMDS data 2+ 7 TMDS data 0+ 13 CEC
2 TMDS data 2 8 TMDS data 0 14 Reserved
shield shield (NC on device)
3 TMDS data 2– 9 TMDS data 0– 15 SCL
4 TMDS data 1+ 10 TMDS clock+ 16 SDA
5 TMDS data 1 11 TMDS clock 17 DDC/CEC
shield shield ground
6 TMDS data 1– 12 TMDS clock– 18 +5 V power
19 Hot plug
detect
HDMI
Type A Connector
1
18 2
19
Figure 6. HDMI Connector Pin Assignments