Extron Electronics DXP HDMI User Guide - Manual (Page 21)

DXP DVI Pro and DXP HDMI Series • Operation 15
Secondary functions ( • ):
• In I/O grouping mode, selects group 1 (see “ I/O Grouping ” on page 31).
• In I/O grouping mode, indicates that group 1 is selected.
• With the Preset, View < , and Esc > buttons, places the switcher in serial port
configuration mode (see “ Selecting the RS-232/RS-422 Protocol and Baud
Rate (Rear Panel) ” on page 43).
• Selects 9600 baud for the Remote RS232/RS422 and the RS-232 Config ports in
serial port configuration mode.
• Indicates that the Remote RS232/RS422 and the RS-232 Config ports are set to
9600 baud in serial port configuration mode.
e Preset button — The Preset button does the following:
Primary functions ( ❏ ):
❏ Places the switcher in preset saving mode to save a configuration as a preset,
and in preset recalling mode to activate a previously-defined preset.
❏ Blinks when the DXP is in preset saving mode and lights steadily when the
switcher is in preset recalling mode.
Secondary functions ( • ):
• In I/O grouping mode, selects group 2.
• In I/O grouping mode, indicates that group 2 is selected.
• With the Enter, View < , and Esc > buttons, places the switcher in serial port
configuration mode.
• Selects 19200 baud for the Remote RS232/RS422 and the RS-232 Config ports
in serial port configuration mode.
• Indicates that the Remote RS232/RS422 and the RS-232 Config ports are set to
19200 baud in serial port configuration mode.
f View < button — The View < button does the following:
Primary functions ( ❏ ):
❏ Places the switcher in view-only mode to display the current configuration.
NOTE: View-only mode also provides a way to mute and unmute outputs
(see “ Muting and Unmuting Video and Audio Outputs ” on
page 35).
❏ Indicates that the DXP is in view-only mode.
Secondary functions ( • ):
• In I/O grouping mode, selects group 3.
• In I/O grouping mode, indicates that group 3 is selected.
• With the Enter, Preset, and Esc > buttons, places the switcher in serial port
configuration mode.
• Selects 38400 baud for the Remote RS232/RS422 and the RS-232 Config ports
in serial port configuration mode.
• Indicates that the Remote RS232/RS422 and the RS-232 Config ports are set to
38400 baud in serial port configuration mode.