Extron Electronics DXP HDMI User Guide User Manual
Page 69
DXP DVI Pro and DXP HDMI Series • SIS Configuration and Control
63
Command
ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Resets
Reset global presets
and names
E
ZG
}
Zpg
]
Clear all global presets and
their names.
Reset an individual global
preset
EX&
ZG
}
Zpg
X&]
Clear global preset
X&
.
Reset all mutes
E
ZZ
}
Zpz
]
Unmute all audio or video.
Reset room map
E
ZR
}
Zpr
]
Clear all room definitions.
Reset individual room
EX^
ZR
}
Zpr
X^]
Delete room
X^
.
Reset all room presets and
names
E
ZP
}
Zpp
]
Clear all room presets and
names.
Reset individual room preset
and name
EX^
*
X*
ZP
}
Zpp
X^
*
X*]
Clear an individual room
preset and name.
Reset whole switcher
E
ZXXX
}
Zpx
]
Clear all ties and presets.
Absolute resets
E
ZQQQ
}
Zpq
]
Similar to the Reset whole
switcher command,
plus clear the IP address
to 192.168.254.254
and subnet mask to
255.255.000.000.
E
ZY
}
Zpy
]
Reset all settings
except IP
and gateway address, subnet
mask, unit name, DHCP
setting, and port mapping
(Telnet, web, and direct
access). This is recommended
for after a firmware update.
Information Requests
Information request
I
V
X1$
X
X1%
•A
X1$
X
X1%]
V
X1$
X
X1%
is the video matrix
size. A
X1$
X
X1%
is the audio
matrix size.
Example:
DXP 48 DVI Pro
DXP 48 HDMI
I
V4X8•A4X8
]
The matrix consists of four
video and audio inputs by
eight video and audio outputs.
Request part number
N
60-nnn[n]-01
]
Show the DXP part number:
DXP 44 DVI Pro = 60-875-01
DXP 48 DVI Pro = 60-1009-01
DXP 84 DVI Pro = 60-876-01
DXP 88 DVI Pro = 60-877-01
DXP 44 HDMI = 60-880-01
DXP 48 HDMI = 60-1010-01
DXP 84 HDMI = 60-881-01
DXP 88 HDMI = 60-882-01
NOTE:
X!
= Input number
1 – maximum number of inputs for your model
X^
= Room number (for room presets)
Each room can have up to 10 presets (
X&
) assigned.
X&
= Global preset number
00 – 32. 00 = current preset
X*
= Room preset number
00 – current ties for the room in view mode, 10 maximum
X1$
= Total inputs
Total number of inputs for this switcher
X1%
= Total outputs
Total number of outputs for this switcher
NOTE:
If the source requires HDCP authentication, ensure that HDCP authorization is set to On (the
default).