Extron Electronics DVS 605 User Guide - Manual (Page 60)

Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Hardwired IR port
Enable IR port
(allows IR) 65*0# IRDisable0 ] Enables the hard wired port and allows IR
control input.
Disable IR port
(blocks IR) 65*1# IRDisable1 ] Disables the hard wired port (default).
View IR setting 65# X( ] View the current IR Disable setting.
Picture In Picture
NOTE: HDMI input 5 cannot be used for PIP.
PIP on/off
PIP on E X2& PIP} Pip X2&] Turn on PIP and display input X2& . X2& is a
two digit response (for example, 01).
PIP off E 0 PIP} Pip 00] Turn PIP off.
View PIP selection E PIP} X2&] View PIP selection ( X2& is a two digit
response, for example, 01).
Swap main/PIP windows
Swap % Tke ] Swap between main and PIP window .
On-Screen Menu time-out
NOTE: Setting the time-out to 501 disables the OSD time-out (never times out). Setting the time-out to 0 disables the OSD.
Set menu time-out E X2% MDUR} MdurX2% ] Set the OSD to X2% seconds.
View time-out E MDUR} X2% ] View time-out settings.
Reset commands
Erase user web
pages and files
24 28
E EF} Del•] Erase named files.
Erase current
directory and
files
24 28
E /EF} Ddl] Erase current directory and its files.
Erase current
directory and
subdirectories
24 28
E //EF} Ddl] Erase current directory and its
subdirectories.
Erase flash
memory
24
E ZFFF} Zpf] Erase the flash memory.
Reset all device
settings to factory
default settings
24
E ZXXX } Zpx ] Retains Ethernet settings
Absolute system
reset
24
E ZQQQ } Zpq ] Includes resetting networking to DHCP =
Off, IP = 192.168.254.254 (default address)
Absolute system
reset (but retain IP)
24
E ZY } Zpy ]
NOTE: This reset E ZY is similar to ZQQQ but excludes IP address, subnet mask, gateway addresses, unit name,
DHCP setting, and port mapping (Telnet/web/direct access) in order to maintain communications with device.
Recommended after a firmware update.
NOTE:
X( = Enable/disable: 0 = off/disable, 1 = on/enable
X2% = On-screen menu time-out: (default = 3 seconds)/output sync time-out (default = 501 - never)
0 = OSD never displayed/output sync is instantly disabled with no active input,
1 to 500 in 1 second increments, 501 = OSD never times out/output sync never times out
X2& = PIP window input selection: 0 to 4 (0 = off)
DVS 605 • SIS Communication and Control 54