Extron Electronics DVS 605 User Guide - Manual (Page 45)

X3^ = HDMI output format:
0 = Auto (based on sink EDID), default
1 = DVI
2 = HDMI 444 RGB (0-255, audio, InfoFrames)
3 = HDMI 444 YUV “FULL” (0-255, audio, InfoFrames)
4 = HDMI 444 YUV “LIMITED” (16-235, audio, InfoFrames)
5 = HDMI 422 YUV “FULL” (0-255, audio, InfoFrames)
6 = HDMI 422 YUV “LIMITED” (16-235, audio, InfoFrames)
X3& = Auto switch mode:
0 = Disable (default)
1 = Gives priority to the highest input
2 = Gives priority to the lowest input
X3* = Audio volume range: -100 dB to 0 dB, in 1.0 dB steps, default = -30 dB (with leading “-”);
where 0 = 0 dB (max volume output)
X3( = Audio output format:
1 = Dual mono
2 = Stereo (default)
X4) = Audio gain/Attenuation: -53 through + 09 dB, (with leading “+” or “–“)
X4! = Audio source:
0 = Follow Main window
1 = Follow PIP window
2 = Toggle source
X4@ = Audio input type:
0 = None, input is muted (EDID has no CEA extension)
1 = Analog, 5-pole captive screw (EDID has no CEA extension)
2 = 2Ch digital, embedded in HDMI input, (2Ch PCM audio requested from source via EDID)
3 = Full digital (via EDID to allow any digital audio format from source)
4 = 2Ch digital, Auto (2Ch PCM audio requested from source via EDID), scaler uses embedded
digital audio when present, or defaults to the input’s analog 5-pole captive screw
5 = Full digital auto (Full audio is requested from source via EDID). Scaler uses embedded
digital audio when present, or defaults to input’s analog 5-pole captive screw.
NOTES: • Inputs 1 and 2 can only be set to X4@ = 0 (all models) or 1 (audio model only).
Attempting to set these inputs to any other format gives an “E14” error message.
• N on-audio models of the DVS 605 will allow X4@ = 0 on inputs 1 and 2, and
X4@ = 0, 2, or 3 on inputs 3, 4, and 5.
X4# = Static audio delay, 0 through 255 milliseconds (default is 0)
NOTE: The static audio delay is in addition to the automatic audio delay that is
applied by the DVS 605 to compensate for internal video processing.
X4$ = Video signal status
0 = Video / TMDS signal not detected
1 = Video / TMDS signal detected
X4% = Power save modes
0 = Full power mode (default)
1 = Low power state
X4^ = Screen saver status
0 = Active input detected; timer not running
1 = No active input; timer is running; output sync still active
2 = No active input; timer has expired; output sync disabled
DVS 605 • SIS Communication and Control 39