Extron Electronics DVS 605 User Guide - Manual (Page 54)

Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Screen saver mode (action that takes place when no signal is detected on the selected input)
Set mode E MX3)SSAV} SsavM X3)] Sets the screen saver mode to X3)
(default: 1 = black).
View mode E MSSAV} X3) ] View the current screen saver mode.
Set sync timeout
duration E TX2%SSAV} SsavT X2%] Sets sync timeout duration to X2% seconds
(default: 501 = never).
View sync timeout
duration E TSSAV} X2%] View sync timeout duration X2% .
View screen saver
status E SSSAV} X4^] View the screen saver status X4^ .
Audio Configuration
Audio mute (global settings)
Mute on 1Z Amt1] Mute selected input.
Mute off 0Z Amt0] Un-mute selected input.
View status Z X(] View mute status (0 = mute off, 1 = mute
on).
Audio gain and attenuation (audio models only: per analog input)
Set gain/
attenuation X4) G AudX4)] Set gain/attenuation on current input to
X4) dB.
Increment +G AudX4)] Increment audio level (up).
Decrement -G AudX4)] Decrement audio level (down).
View G X4)] View current audio level.
Volume control (audio models only)
Set specific volume X3* V VolX3*] Set volume to X3* .
Increment +V VolX3*] Increase volume.
Decrement -V VolX3*] Decrease volume.
View V X3*] View current volume setting.
Audio delay (available on all models)
Set static delay E SX4#ADLY} AdlyS X4#] Set static audio delay to X4# ms (range =
0-255 ms).
View setting E SADLY} X4#] View audio delay ( X4# ) in milliseconds.
NOTE: X( = Enable/disable; 0 = Off/disable, 1 = On/enable
X2% = On-screen menu time-out: (default = 3 seconds), output sync time-out (default = 501 - never)
0 = OSD never displayed/output sync is instantly disabled with no active input,
1 to 500, in 1 second increments, 501 = OSD never times out/output sync never times out
X3) = Screen saver mode: 1 = Black screen (default), 2 = Blue screen with OSD text
X3* = Audio volume range: 000 to -100 dB (default = -30 dB), in 1.0 dB step, with max = 0 dB and min = -100 dB.
attenuation, plus hardware mute
X4) = -53 through +09 dB, (with leading “+” or “–“)
X4# = Static audio delay: 0 through 255 milliseconds
X4^ = Screen saver status: 0 = Active input detected; timer not running, 1 = No active input; timer is running;
output sync still active, 2 = No active input; timer has expired; output sync disabled
DVS 605 • SIS Communication and Control 48