Extron Electronics DVS 605 User Guide - Manual (Page 33)

Front Panel Lockout (Executive Modes)
To prevent accidental changes to settings, press the Menu and Next buttons
simultaneously for 2 seconds to enable front panel lockout mode (executive mode 2).
The menu system returns to the default menu within 10 seconds.
Executive mode 2 locks all front panel functions except input switching, PIP enable and
PIP swap, and Auto‑Image. Menu and Next buttons and the Adjust knobs are disabled.
When executive mode 2 is active, all functions and adjustments can still be made
through USB, RS‑232, or Ethernet control. For details on remote control, see “
SIS
Communications and Control ” starting on page 34.
To disable executive mode 2, press the Menu and Next buttons simultaneously for
2 seconds. See the flowchart below.
Menu
Press both for
2 seconds
Next
EXEC. MODE 2
ENABLED
Enable Executive Mode
EXEC. MODE 2
DISABLED
Disable Executive Mode
Menu
Press both for
2 seconds
Next
2
sec. In RGBHV
#1 640x480
In 31.47 kHz
#1 59.94 Hz
Output
720p@60
3 sec.
timeout
3 sec.
timeout
Figure 22. Front Panel Lockout
Executive mode 1 locks all front panel functions completely. This mode can be enabled
or disabled by SIS commands only.
DVS 605 • Operation 27