Menu overview – Extron Electronics DVS 605 User Guide User Manual

Page 20

Menu Overview

After start‑up, and when no adjustments are actively being made, the “default cycle”
appears on the LCD. The screens cycle between the screen that shows the number and
video format of the active input and the current output resolution.
Pressing the Menu button once brings up the first of eight main (top level) menus, as

shown below. Each successive press of the Menu button goes to the next main menu.

USER

PRESETS

INPUT

CONFIG

PICTURE

CONTROL

OUTPUT

CONFIG

AUDIO

CONFIG

ADVANCED

CONFIG

VIEW COMM

SETTINGS

EXIT MENU?

PRESS NEXT

2 sec.

sec.

Default Display Cycle

IN RGBHV

#1 640x480

IN 31.47 kHz

#1 59.94 Hz

OUTPUT

720p@60

2 sec.

Figure 9.

Top Level Menus

A fourth default cycle menu appears only when genlock is enabled. See “

Genlock/AFL

Mode

”on page 20) for details.

NOTE: From any menu or submenu, after 20 seconds of inactivity the DVS will save

all adjustment settings and time‑out to the default cycle.

The

flowchart

shown on page 15 provides an overview of the complete menu system,

with configuration submenus and the options for each setting. In the flow charts the use
of “x”, (for example in (x) or Inx) indicates an input number.
Use the Menu button to scroll between top level menus and press Next to enter the

submenus.

NOTE: If no signal is present on the currently selected input, NO SIGNAL appears in

place of the input type. For example, INPUT 4 NO SIGNAL.

Details of each of the menus are on subsequent pages after the main flow chart.

DVS 605 • Operation