Extron Electronics MAV Plus Series User Guide - Manual (Page 59)

Example 5: Grouping inputs and outputs
In the following example, several switcher inputs and outputs are assigned to groups. The
steps show the front panel indications that result from your action.
1. Clear all selections: Press and release the Esc button.
2. Enter I/O Group mode: Press and hold the Input 1 and Output 1 buttons for
approximately 2 seconds and then release the buttons.
1 2 5 16
17 18 11 32
1 2 5 16
17 18 11 32
I
N
P
U
T
S
O
U
T
P
U
T
S
1 2 5 16
17 18 11 32
1 2 5 16
17 18 11 32
I
N
P
U
T
S
O
U
T
P
U
T
S
•
Press and hold
the Input 1 button
and Output 1 button.
Release the buttons.
Ungrouped input and
output buttons light.
2 seconds
3. Select group 1: Press and release the Enter button.
C O N T R O L
PRESET ENTER ESC VIEW
1 3 2 4
Press and release the Enter button to select group 1.
The button lights to indicate the selection.
Group #
NOTE: I/O groups are protected when front panel lock mode 2 is selected. You can
view the groups in lock mode 2, but you cannot change them from the front panel
(see
Setting the Front Panel Locks (Executive Modes) on page 75).
If front panel lock mode 2 is selected and you try to perform step 4, the actions
are ignored and the Enter, RGBHV or Video, and Audio buttons flash.
4. Assign inputs and outputs to group 1:
a. Press and release the Input 1 through 4 buttons.
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
I
N
P
U
T
S
Press and release the Input 1 through Input 4 buttons.
The selected buttons light.
b. Press and release the Output 1 through 4 buttons.
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
O
U
T
P
U
T
S
Press and release the Output 1 through Output 4 buttons.
The selected buttons light.
CrossPoint and MAV Series Matrix Switchers • Operation 53