Extron Electronics MAV Plus Series User Guide - Manual (Page 127)

7. Click Tools > Update firmware ... .
• If the switcher is connected via the LAN port, the select file window appears
(see figure 69 and “Ethernet-connected firmware upload,” below).
1
Figure 69. Select File Window
• If the switcher is connected via either serial port, the Extron Firmware Loader
window appears (see
figure 70 and Serial-port-connected firmware upload
on the next page).
Ethernet-connected firmware upload
1. Navigate to the folder where you saved the firmware upgrade file. Select the file.
2. Click the Open button. The software advises you that you are about to reprogram the
switcher firmware. Click OK to continue.
A status window, which shows the progress of the upload,
appears. The firmware upload to the matrix switcher may
take a few minutes.
CrossPoint and MAV Series Matrix Switchers • Matrix Software 121