Extron Electronics MAV Plus Series User Guide - Manual (Page 151)

Mute and unmute one or all outputs
Mute one or all outputs as follows:
1. To select an individual output to mute or unmute, click the Output drop box. A
drop down scroll box appears (see figure 95).
Figure 95. Output Selection Drop Box
2. Click and drag the slider or click the scroll up button or scroll down button until the
desired output is visible.
3. Click the desired output.
4. Click the Video Only , Audio Only , or Video & Audio button to select video, audio, or
both for muting. Each mouse click on a button toggles the other two buttons off.
5. Click the Mute or UnMute button to mute or unmute the selected output.
6. Click the Mute All or UnMute All to mute or unmute all of the outputs.
Observe the Mute status indications on the page.
Unmuted is displayed in green and Muted is displayed in red.
Change the RGB delay (CrossPoint switchers)
The RGB delay interval defines how long the screen is blanked when switching to a new
input for the selected output.
Change the RGB delay as follows:
1. Click the Output drop box. A drop down scroll box appears (see figure 96).
Figure 96. Output Selection Drop Box
2. Click and drag the slider or click on the scroll up button or scroll down button until
the desired output is visible.
3. Click the desired output.
CrossPoint and MAV Series Matrix Switchers • HTML Operation 145