Extron Electronics MAV Plus Series User Guide - Manual (Page 25)

Figure 14 shows a MAV Plus 248 A audio matrix switcher (audio only).
NOTE: The MAV Plus 328 is housed in the same 3U enclosure, but has more input
connectors to accommodate its larger matrix size.
INPUTS
OUTPUTS
L 1 R L L R 2 L 3 R 4 R 5 L R 6 L R L R 7 R L 8
L 17 R L L R 18 L 19 R 20 R 21 L R 22 L R L R 23 R L 24
L 9 R L L R 10 L 11 R 12 R 13 L R 14 L R L R 15 R L 16
L 1 R L L R 2 L 3 R 4 R 5 L R 6 L R L R 7 R L 8
LISTED 1T23 I.T.E. C U S
RESET
LAN
LINK
ACT
RS232/RS422
REMOTE
RESET
LAN
12
5
4
8
9
10
Figure 14. MAV Plus 248 A Matrix Switcher
Rear Panel Connections
ATTENTION:
• Use ESD precautions (be electrically grounded) when making connections.
Electrostatic discharge can damage equipment, even if you cannot feel, see, or
hear it.
• Remove system power before making all connections.
Video Input and Output (Video Models)
NOTE: The switchers do not alter the video signal in any way. The signal output by the
switcher is in the same format as the input.
RGBHV (CrossPoint switchers)
The switcher can connect to up to as many as 32 (CrossPoint 450 Plus) or 16
(CrossPoint Ultra) RGBHV video sources, depending on the model. The switcher can output
to as many as 32 or 16 RGBHV video devices, depending on the model.
NOTES:
• On all CrossPoint 450 Plus switchers and CrossPoint Ultra matrix sizes of 8 x 16
and larger, the connectors for each video plane are grouped together (all of the red
inputs grouped together, all of the green inputs grouped, and so on). Ensure that
you connect the input on each video plane to the corresponding connector in the
correct group (see
figure 15 , on the next page).
• Both CrossPoint models can also switch RGBS, RGsB, RsGsBs, component video,
S-video, or composite video by using four, three, two, or one BNC(s). If switching a
video format other than RGBHV, ensure that the same video planes (R, G, B, H/HV,
or V) are used on the switcher output as on the input.
a
Video inputs — Connect RGB video, component/HDTV video, S-video, or composite
video inputs, as applicable, to these BNC connectors for each input. Figure 15 , on the
next page, shows how to connect the RGB video format to each configuration.
b
Video outputs — Connect RGB video, component/HDTV video, S-video, or
composite video displays, as applicable, or other devices to these BNC connectors
for each output.
Figure 15 , on the next page, shows how to connect the RGB video
format to each configuration.
CrossPoint and MAV Series Matrix Switchers • Installation 19