YSI IQ S ENSOR N ET DIQ/S 182 XT - Manual (Page 78)

Operation System 182
4 - 6 ba76022e01 12/2011
4.3.3 Entry mode
In the entry mode, you can change individual values or enter a
character string. Depending on the value type, change a value as
follows
 Fixed values of a selection list (e.g. sensor measuring ranges):
This is the most frequent form of an entry. Select the required option
with the toggle switch
w
and confirm the selection with
g
. The
display switches back to the setting table.
Fig. 4-5 Example of a selection list
 Character strings (text and numerals):
The following letters, numerals and special characters can be
entered: AaBb..Zz0..9µ%&/()+-=>.
Entries are made character after character. Select the first character
with the toggle switch
w
and press
g
. The entry mark moves to
the next position and indicates
P
. Select the next character with the
toggle switch
w
. When you have selected the required sequence
of characters select
P
as the following character and press
g
. The
entry is completed with this and the display switches back to the
setting table.
Fig. 4-6 Example of text entry
If you want to correct a previously selected character while entering,
select the thin arrow to the left
b and press g
. This moves the
entry mark by one digit to the left. Thus you can go back to the
required character. All characters on its right side, however, have to
be entered once again.
If you want to restart entering the characters, select the thick arrow
to the left
B and press g
.