YSI IQ S ENSOR N ET DIQ/S 182 XT - Manual (Page 168)

Installation MIQ/CR3; DIQ/CR3
3 - 2 ba76032e01 01/2012
3.3 Electrical connections: General instructions
Cable glands All electric cables are fed from below via prepared openings in the
enclosure of the module. Cable glands with different clamping ranges
are included with the module to provide sealing between the cable and
enclosure as well as for strain relief. Select the matching cable gland
for the respective cable diameter:
 Small, clamping range 4.5 to 10 mm. This cable gland is suitable for
all IQ S
ENSOR N ET sensor cables.
 Large, clamping range 7 to 13 mm. This cable gland is required for
cable sheaths with an outside diameter of more than 10 mm and is
screwed into the enclosure via an extension piece.
Note
If necessary, you can order more large cable glands in a set of 4 pieces
(Model EW/1, Order No. 480 051).
sealing ring 20 x 15 x 1 mm
cable gland M16
blind plug
sealing ring 20 x 15 x 1 mm
extension piece M16/M20
sealing ring 24 x 19 x 2 mm
cable gland M20