YSI IQ S ENSOR N ET DIQ/S 182 XT - Manual (Page 131)

System 182 Maintenance and cleaning
7 - 1 ba76022e01 12/2011
7 Maintenance and cleaning
7.1 Maintenance
Maintenance activities
7.2 Cleaning
IQ S ENSOR N ET ,
DIQ modules,
MIQ modules
Clean components mounted in the open of gross contamination as
necessary. We recommend to clean the worst of the dirt on the
enclosure and the area around it each time before opening in order to
prevent gross contamination from entering the open enclosure.
To clean the module, wipe the enclosure surfaces with a damp, lint-free
cloth. If compressed air is available on site, blow off the worst of the dirt
beforehand. Keep the enclosure closed while doing so.
Caution
The enclosure and the window of the display are made of plastic.
Therefore, avoid any contact with acetone or similar cleaning
agents. Any splashes must be wiped off immediately.
Caution
Never use high-pressure cleaners to clean components of the
IQ S
ENSOR N ET .
IQ sensors The cleaning of the IQ sensors depends greatly on the respective
application. Instructions for this are given in the respective component
operating manual.
Component Maintenance
IQ sensors Depending on the type of sensor
(see the component operating
manual of the sensor)
IQ S ENSOR N ET ,
DIQ modules,
MIQ modules
No maintenance required