YSI IQ S ENSOR N ET DIQ/S 182 XT - Manual (Page 173)

MIQ/CR3; DIQ/CR3 Settings
4 - 1 ba76032e01 01/2012
4 Settings
The combi output module has three relays outputs and three current
outputs.
 Relay outputs operate as openers or closers.
 Current outputs provide a current that depends on the measured
value.
On the terminal or Universal Transmitter, you can
 assign names to the outputs (with the 2020 XT system only, see
section 4.2).
 link outputs with sensors (see section 4.3)
 delete links of outputs with sensors (see section 4.4)
 adjust outputs (see section 4.5 and section 4.6)
 check the condition of the outputs (see section 4.7)
Basic information on how to use relay outputs is given in section 4.1.
Note
The general operating principles are given in the relevant system
operating manual or in the component operating manual of the terminal
components.
Functions of current and
relay outputs
Relay output (see section 4.5)
 System monitoring
 Sensor monitoring

Limit indicator
 Frequency controller

Pulse-width contr.
 Cleaning

Sensor-controlled
 Manual control
 Alarm contact (with the 2020 XT system only)
Current output (see section 4.6)
 Recorder
 PID controller
 Fixed current value